Smeg KCVB9SG, Инструкция по эксплуатации

Страница: 8 / 9

EN
Keypad lock:
Locks keyboard functions (for example, when cleaning the glass surface)
when all the loads are off and no alarm is on. To enable/disable this
function, press the
BOOST-SPEED button for about 5s until the two
central segments of every digit on the display light up.
FILTER SATURATION ALARM;
RESETTING THE HOOD WORKING HOURS COUNTER
• After the hood has been running for 100 hours the display shows FF,
meaning that the GREASE FILTERS should be cleaned;
• After 200 hours of running, the display shows
EF, meaning that the
GREASE FILTERS should be cleaned and the A.C. filter cartridges
replaced (the latter warning appears only if the A.C. FILTER alarm
function has been enabled).
NOTE: The warnings appear on the display only when the blower
motor is off.
Direct procedure for enabling/disabling remote control
Turn off the motor and the lights and make sure that no alarms are on
(filter saturation). Press and hold the
DELAY button for about 5s, until:
• “tc” flashes twice on the display, meaning that the remote control has
been enabled;
• “tc” flashes once on the display, meaning that the remote control has
been disabled.
SET-UP procedure
The default configuration is as follows:
• 400W motor powered by 230 VAC – 50/60 Hz;
• A.C. FILTER saturation alarm disabled;
• remote control disabled.
ACCESSING THE SET-UP PROCEDURE:
1) To access the set-up procedure press button 24 for about 5s, until
an animation appears on the display; when the animation starts you have
about 5 seconds to perform the set-up:
• Press V- to enable/disable the A.C. filter saturation alarm EF flashes
twice when enabled and once when disabled
.