GB
10
3.7.2
Use of the furniture door fixing template
Proceed in the following way when applying the wooden panel to the washing dryer:
1. When f itting the f urniture door utilising the door template y ou will need to make sure that the bottom and
the top of the f urniture door will line up with the adjacent cabinet furniture doors.
2. The f inal positioning of the f urniture door hinges will be dictated to by the height or the plinth plus any ad-
ditional base-board used in conjunction with raising the height of the washer dryer for cosmetic purposes
3. Calculate the height of the plinth.
4. There are two holes “
A
” in the upper part of the template. These will hav e been perforated and are used
to mark the holes that will subsequently house the upper hinge and the insert for the closing hook. The
small central hole “
B
” is used to mark the position of the metal plate f ixing hole when f itting the magnetic
catch.
5. Remov e the f our pieces of protectiv e f ilm from self-adhesive areas “
C
” of the template
6. Position the template on the inside of the f urniture door taking in to consideration point one above.
7. Ensure that you have placed the template in the correct position making sure that it is vertically and hori-
zontally correct with reference to the guides on the template and mark the positions of the holes with a
pencil.
8. After hav ing set the template in its correct position and after hav ing also checked that is centered in a
horizontal direction with reference to the lines marked at the ends, mark the positions of the holes using
the tip of a pencil.
3.7.3
Fitting the hinge components to the furniture door
1. Drill holes in the furniture door f or the hinges, the door buffer and the closing hook, using a pedestal
mounted drill and a suitable 35mm f urniture drill bit, drill 4 number 13mm deep holes into the f urniture
door (Care must be taken not to exceed 13mm or the door f ascia could be damaged). Please note that if
the magnetic door catch is required then a small pilot hole is all that is needed
2. On the hinge side of the f urniture door drill four number 2mm x 13mm deep holes f or the hinge fixing
screws (Care must be taken not to exceed 13mm or the door fascia could be damaged)
3. Screw the two hinges “
A
” into the f urniture door, according to whether the furniture door is left or right-
hand hinged.
