Operation
GB
27
Power boost setting
(cooking zones marked with a P)
The power boost setting makes additional power available for induction
cooking zones. A large quantity of water can be brought to the boil very
quickly.
The power boost setting operates for 10 minutes, after which the power level
is automatically reduced to cooking level 9.
1. A cooking zone must be switched on. The stand-by dot of the cooking
zone must light up. It may be necessary to press the
cooking zone
selection button
.
2. Press the
power button
once in order to activate the power boost set-
ting. The power display will show a P.
3. After 10 minutes the power boost setting will switch off automatically. The
P will go off and the power level will switch down to 9.
Note!
In order to terminate the power boost setting press the
minus button
or
the
power button
.
Dual circuit activation for radiant heating
elements (not for induction)
In order to switch on the outer heating circuit select the cooking zone (stand-
by dot lights up) and press the
power button
.
In order to switch the function off press the button again or switch the cooking
zone off.
Power management
For technical reasons two cooking zones always comprise a module and
have a maximum power level.
If this power range is exceeded when a higher power setting level or the
power boost function is switched on the power management system will
reduce the power setting of the corresponding cooking zone of the module.
The display of this cooking zone will initially blink; the maximum possible
power setting will subsequently be shown constantly.
Modules (power management)
