Smeg FR315P, Инструкция по эксплуатации

Страница: 14 / 31

FI DK NO SE GR IT PT ES NL FR GB DE
5
0
1
9
6
0
0
0
0
3
8
5
P
ri
n
te
d
i
n
I
ta
ly
0
1
/1
3
What to do if... Possible causes: Cures:
The control panel is
switched off, the appliance
does not work. There may be an appliance
power supply problem.
The appliance could be in
On/Standby mode.
Make sure:
- there is not a power outage
- the plug is properly inserted in
the power socket and the mains
double-pole switch (if present) is
in the correct position (i.e. allows
the appliance to be powered)
- the household electrical system
protection devices are efficient
- the power cable is not broken.
Activate the appliance with the
Temp. button.
The inside light does not
work. The light may need replacing.
Malfunction of a technical
component. Contact an authorized Service
Centre.
The inside light flashes. Door alarm active
It is activated when the
refrigerator compartment door
remains open for a prolonged
period of time. To stop the alarm, close the
refrigerator door.
On reopening the door, check the
light works.
The temperature inside the
compartments is not low
enough. There could be various causes
(see “Solutions”). Make sure:
- the doors close properly
- the appliance is not installed near
a heat source
- the set temperature is adequate
- the circulation of air through
the vents at the bottom of the
appliance is not obstructed.
There is water on the
bottom of the refrigerator
compartment. The defrost water drain is
blocked. Clean the defrost water drain
hole (see the section “Appliance
Maintenance and Cleaning”).
The front edge of the
appliance, at the door
striker seal, is hot. This is not a defect. It prevents
condensation from forming. No solutioin is necessary.
One or more green lights
flash continuously. Malfunction alarm
The alarm indicates a fault in a
technical component. Call the authorised Service Centre.