14 / 32 EN
Refrigerator / User Manual
Installation
C
If the filter usage time is calculated
automatically, Filter Change Warning
indicator will illuminate continuously in a
few seconds after the product is plugged
in.
C
Automatic filter usage time calculation is
not enabled ex factory. It must be enabled
in products equipped with a filter.
C
If the same procedure is repeated when
the automatic filter usage time calculation
is enabled, then the function will be
cancelled.
3.13 Before starting to use the
water/ice dispenser
•
If the water pressure is below 1 bar or a
demijohn will be used, than a separate must be
used as well.
•
Water system of the refrigerator must be
connected to the cold water line.
It must not
be connected to hot water line.
•
No water may be obtained in the initial start-
up of the refrigerator. Because there is air in
the system. To discharge air from the system,
press dispenser latch for 1-2 minutes until
water comes from the dispenser. Water flow
may be irregular at the beginning. After the
air in the system is discharged, water flow will
return to normal.
•
During initial use, you will have to wait
approximately 12 hours for the water to cool
down.
•
It will take around 1-2 days for the system to
produce required amount of ice.
•
Water pressure must be between 1-8 bars for
the operation of ice/water dispenser smoothly.
For this, check that 1 glass of water (100 cc)
can be filled in 10 seconds.
•
The first 10 glasses of water should not be
consumed.
•
You must wait approximately 12 hours to
obtain ice from the ice dispenser for the first
time. If there is not enough ice in the ice
container, ice may not be obtained from ice
dispenser.
•
Do not consume the first 30 pieces (3-4 Litres)
of ice cubes.
•
First several glasses of water may be turbid
when the filter is used for the first time.
Therefore, do not consume the first several
glasses of water.
•
If the water dispenser is not used for a long
period of time, first 1-2 glasses of water can
be hot.
•
If a power outage or a temporary failure occurs
while the refrigerator is operating, ice can melt
down a little bit and then get frozen again. In
such a case, ice cubes can stick to each other.
If the outage or failure prolongs, ice can melt
down causing water leakage. If you experience
such a problem, empty and clean the ice
container.
•
Ice cubes can stick to each other if they are left
in the container for a long time.
•
Water system installation of the refrigerator
must be performed by the Authorised Service
Agent.
•
If the product is to be connected to the water
mains, make sure that you use potable water.
•
Water system of the product is designed to
operate only with water. Do not use beverage
such as soft drinks and/or juices in the water
system.
