Mounting Instructions
12
Mounting the Appliance
x
Push the appliance for some 38 mm into the kitchen unit and
allow at least 4 mm free space on both sides between the
appliance and the side walls of the kitchen unit (Fig. 1).
x
Widely open the door and put it together with the kitchen unit
door. The procedure is as follows.
Fix the slide guides (attached in a plastic bag along with the
screws ST 4,2 x 9,5) to the edge of the door. Cover the open
holes with the attached cap.
Put together the appliance door and the door of the kitchen
unit (Fig. 2).
Insert the slides into the guides and fix them on the kitchen
unit door some 15 mm from the edge, using the A 4 x 12
screws (Fig. 3).
Remove the slide guides and separate the appliance door
from the door of the kitchen unit.
Fix the slides and be careful not to move them while fixing
(Fig. 4).
Fix the slide guides to the original position.
Close the door and check the gasket (it should not be
creased). The door should open and close smoothly.
NOTE:
Appliance with the height of 575 mm have only one slide and one
slide guide.
x
Fix the appliance into the kitchen unit. On the upper side, fix the
three screws A 4 x 12 through the rail and on the lower side with
two screws A 4 x 16, through the lower hinges. Drill holes,
ø 3 x 5 (Fig. 5).
x
Seal the gap on the opposite side of the hinge with the
enclosed seal (Fig. 6).
WARNING
Before mounting the appliance into the kitchen unit, disconnect
the power supply and set the thermostat knob to STOP (0)
position or switch off the ON/OFF switch.
