Instructions for the installer
21
2. POSITIONING OF HOB
The following operation requires building and/or carpentry work so must
be carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry,
metal, solid wood or plastic laminated wood as long as they are heat
resistant (T 90°C).
2.1.1 Attachment to support structure
Create an opening with the
dimensions shown in the figure in the
top surface of the counter, keeping a
minimum distance of
50 mm
from
the rear border.
This appliance can therefore be
mounted against walls higher than
the work surface on condition that a
certain distance “
X
” be kept between
the appliance and the wall as shown
in the figure so as to avoid damage
from overheating.
Make sure there is a minimum of
750 mm
between the hot plate flames
and any shelf that may be installed directly above them.
Carefully position the insulation gasket (supplied) on the external
perimeter of the hole made in the top surface (see figures below) and try
to make it stick to the entire surface by applying light pressure with your
hands. Refer to the coordinates shown in the figure, bearing in mind that
sides
A
should be adjacent to the hole. Secure the hob to the counter
with brackets
B
(supplied). Carefully trim any excess from border
C
of the
gasket. The distances in the following drawing refer to the hole
on the
inner side
of the gasket.
