Smeg DRY72BK, Инструкция по эксплуатации

Страница: 13 / 16

129316
Water condensation device should be cleaned three to four times
a year, in case of very frequent use even more often.
During cleaning a certain amount of water may drip out so it is
good to put an absorbing cloth below the opening.
• Open the exterior lid of the condenser by grabbing the handle
on the lower left part of the appliance housing and pull it
downwards.
• Remove the interior lid by fi rst turning the lever vertically down,
then tilt the lid towards yourself and remove it.
• Turn the lock on the condenser upwards and pull the
condenser out by pulling the lever.
• Clean the device from both sides with lukewarm water and
drain it well.
• Before replacing it into its slot, clean the air channel in which
the device is mounted, and the gasket at the interior lid.
• Lock the condenser into its place.
• Insert the inner lid to seal well and lock it with a handle.
• Push the exterior lid towards the appliance to lock to its place.
After fi ve drying cycles you need to do the following:
• remove, clean/wash and re fi t the fi lters on the interior side of
the door and the bottom side of door opening;
• remove, clean/wash and re fi t water condenser;
• wipe the inside of the water condenser compartment with a
damp cloth;
• wipe the entire back of the water condenser housing with a
damp cloth (reach deeply into the condenser compartment
with your hand to touch the back wall of the compartment!);
• wipe all sealings and sealing surfaces of the condenser,
condenser housing and condenser door with a damp cloth.
• Periodically clean (vacuum) the interior of air evacuation
opening and evacuation tube.
Cleaning the water
condensation device Cleaning the water
condensation device
Cleaning of evacuation
drier Cleaning of evacuation
drier
13