Smeg DF613PW, Инструкция по эксплуатации

Страница: 42 / 42

User instructions
40
6. Troubleshooting
The dishwasher is equipped with a self-diagnostics system that is capable
of detecting and signalling a number of possible faults.
TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM
FAULT DESCRIPTION
E 01
The anti-flooding system (where present) has been tripped service.
E 02
The water level limitation system has tripped.
E 03
The appliance cannot heat the water.
E 04
The temperature sensor is disconnected.
E 05
The appliance cannot take in the water.
E 06
The appliance cannot drain the water from the tank.
E 07
The dishwasher cannot measure the precise water quantity that has
been loaded.
E 08
Problem on the water distribution system to the baskets.
E 09
Water intake system malfunction.
E 11
Wash motor pump does not work
If an alarm occurs the appliance interrupts the program in progress and signals a fault.
 Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program immediately.

The E5 , E6 alarms interrupts the running program once the cause is resolved, it will
bring bach the execution of the program.

The alarm E7 is visualized at the end of the cycle that comes, however, brought to the
end since the operation of the dishwasher is not harmed.

Alarm E11 :
contact your authorised Service Centre
To “reset” an alarm is necessary:

Open and close the door, or turn off and on the machine. At this point is possible to
program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.