Smeg AS 61 E, Руководство по эксплуатации продукта, Страница: 12 / 12

12 - EN
6
Solution suggestions for problems
Problem Cause Explanation / Suggestion
Drying process takes
too much time.
Cover filter and filter drawer might have
not been cleaned.
* Clean the cover filter and Filter drawer.
Laundry come out wet
at the end of drying.
* Cover filter and filter drawer might
have not been cleaned.
* Excessive laundry might have been
loaded in.
* Clean the cover filter and Filter drawer.
* Do not overload the machine.
Machine does not
switch on or the
program does not
start. Machine is not
activated when set.
* It might have not been plugged in.
* The loading door may be ajar.
* Program might have not been set or
the “Start/Pause/Cancel” button might
have not been pressed.
* “Childproof lock” might have been
activated.
* The condenser cover on the models
with a condenser might not be closed
securely.
* Make sure that the machine is plugged
in.
* Make sure that the loading door is
properly closed.
* Make sure that the program has been
set and it is not in “Pause” mode.
* Deactivate the childproof lock.
* Make sure that the condenser cover
and the red lock is closed securely.
Program has been
interrupted without
any cause.
* The loading door may be ajar.
* Electricity may be cut off.
* Make sure that the loading door is
properly closed.
* Press “Start/Pause/Cancel” button to
start the program.
Laundry has shrunk,
become felted or
deteriorated.
* A program suitable for the laundry
type might have not been used.
* Dry only the laundry which is suitable
for drying in your machine after checking
the labels on your clothes.
* Select a program with suitable low
temperature for the laundry type to dry
your clothes.
Drum lightning does
not come on.
(for models equipped
with a lamp)
* The machine might have not been
started by using the On/Off button.
* Bulb may have blown.
* Make sure that the machine is On.
* Call the authorized service to replace
the bulb.
“Final / Anti-creasing”
LED flashes.
* The 2-hour anti creasing program to
prevent laundry from creasing might
have been activated.
* Turn off the machine and take out the
laundry.
“Final / Anti-creasing”
LED is on.
* Program has come to an end.
* Turn off the machine and take out the
laundry.
The “Drying” LED
flashes.
* A heat sensor failure has occurred.
Machine ends the program without
heating.
* Turn off the machine and take out the
laundry. Call your authorized service.
Also for products equipped with a condenser
“Water tank” warning
LED is on.
* Water may be full.
* Anti-creasing program might be
running.
* Drain the water in the water tank.
“Filter cleaning” LED
is on.
* Filter might have not been cleaned. * Clean the cover filter.
“Condenser cleaning”
LED is on.
* Filter drawer/Condenser might have
not been cleaned.
* Clean the filters in the condenser/filter
drawer under the kick plate.
A
Call an authorized service if the problem persists.