smdv Flash Wave-5TX, Руководство пользователя

Страница: 3 / 5

①
MODE Button
Name of part Description No.
The TTL, Manual(M), Manual High Speed sync(M+HSS), TTL and High Speed Sync(TTL+HSS mode)
are selectable.
· TTL - The Flash will calculate the correct flash exposure then fire the exact flash output for the
subject when the camera shutter speed is set under 1/250 sec.
The Flash exposure compensation is adju/-0.1~3 in 0.1 stop increments.
When the desired flash output in TTL mode is found, it can be fixed by setting on Manual mode.
· M - The desired flash output can be selected under 1/250sec shutter speed.
· M+HSS - The desired flash output can be selected at high speed shutter up to 1/8000 sec.
· TTL+HSS - The Flash will calculate the correct flash exposure then fire the exact flash output for
the subject when the camera is set at high speed sync up to 1/8000 sec.
⑦
Group Setting
Press the A button then set the desired light output and exposure compensation on group A Flash
only. With each Group button, you can select the single group’s flash setting.
All the flashes set in groups should be set on same Channel. But the setting mode(TTL or M)
can be set separately. The individual flash can be powered ON/OFF by pressing the each Group
button for 2 seconds on the transmitter.
②
RPT-Times
You can set a firing flash number by pressing this button.
③
RPT-Hz
You can set a firing flash frequency(number of flash per second, Hz) by pressing this button.
⑤
Test
You can check the correct flash firing condition by pressing this button.
⑥
Battery
It shows the battery status.
④
Channel Setting
Push and hold the Channel button until the channel number begins to blink, then press (
＋
) or (
－
)
button to select the desired channel number among 80 individual channels.
⑧
LED Modeling
No Icon : Modeling light OFF
: Auto LED level control - The LED brightness is automatically adjusted by changing the
output of the flash.
: Full LED - It helps to check the direction of light on the subject before shooting.
: AF-ON - It is operated when camera shutter button is pressed in halfway. The modeling
light is On when the camera lens is set on AF only.
This mode is recommended for battery saving.