SMC Networks ZSE30AF-#-#-X576, Руководство по эксплуатации

Страница: 60 / 68

-59-
No.PS
※※
-OMV1001
Specification
Model No. X576 X577 X578 X579 X580
Rated pressure range ±500 Pa ±1.000 kPa ±2.00 kPa ±5.00 kPa ±10.00 kPa
Set pressure range (Refer to page 61) ±525 Pa ±1.050 kPa ±2.10 kPa ±5.25 kPa ±10.50 MPa
Withstand pressure 2.5 kPa 5 kPa 10 kPa 25 kPa 50 kPa
Applicable fluid 1 Pa 0.001 kPa 0.01 kPa 0.01 kPa 0.01 kPa
Power supply voltage Air, inert gases and incombustible gases
Current consumption 12 to 24 VDC ±10%, ripple (p-p) 10% or less
Switch output 40 mA or less
Digital filter
Rough adjustment mode: 0, 0.2, 0.5, 1, 2, 5, 10, 20 s
Fine adjustment mode: 200 to 1000 ms (increments of 5 ms)

: The digital filter set value affects the response of the pressure display,
analogue output and switch output. (See Figure on page 60 )
Switch output
NPN or PNP open collector output: 1 output
NPN or PNP open collector output: 2 outputs
Max. load current 80 mA
Max. applied voltage 28 V (NPN output)
Residual voltage 1 V or less (at 80 mA load current)
Delay time
4 ms or less
(with anti-chatter function: 20 ms, 100 ms, 500 ms, 1000 ms, 2000 ms,
10 s, 30 s or 60 s selected)
Short circuit protection Provided
Repeatability
±1
％
F.S. ±1 digit
Hys
teresis
Hysteresis mode
0 to variable

1
Window comparator mode
OUT2
Voltage
output

2
Output Voltage
(rated pressure
range)
1 to 5 V ±2.5
％
F.S.
Linearity
±1.5
％
F.S. ±1
％
F.S.
Output impedance approx. 1 k

Current
output

3
Output current
(rated pressure
range)
4 to 20 mA ±2.5
％
F.S.
Linearity
±1.5
％
F.S. ±1
％
F.S.
Load impedance
Max. load impedance: 300

(at power supply voltage of 12 VDC)
600

(at power supply voltage of 24 VDC)
Min. load impedance: 50

Display 4 digits, 7-segment, dual-colour display (red/green)
Display accuracy ±2%F.S. ±1digit (at ambient temperature 25±3

C)
Indicator LED LED is ON when output is ON OUT1: Green OUT2: Red

1: If the applied voltage fluctuates around the set value, the hysteresis must be set to more than the fluctuation width. Otherwise,
chattering will occur.

2: If analogue voltage output is selected, the analogue current output cannot be selected.

3: If analogue current output is selected, the analogue voltage output cannot be selected.