S
PANNING
T
REE
C
OMMANDS
4-173
spanning-tree priority
This command configures the spanning tree priority globally for this
switch. Use the
no
form to restore the default.
Syntax
spanning-tree
priority
priority
no spanning-tree
priority
priority
- Priority of the bridge. (Range: 0 - 65535)
(Range – 0-61440, in steps of 4096; Options: 0, 4096,
8192, 12288, 16384, 20480, 24576, 28672, 32768, 36864,
40960, 45056, 49152, 53248, 57344, 61440)
Default Setting
32768
Command Mode
Global Configuration
Command Usage
Bridge priority is used in selecting the root device, root port, and
designated port. The device with the highest priority becomes the STA
root device. However, if all devices have the same priority, the device
with the lowest MAC address will then become the root device.
Example
spanning-tree pathcost method
This command configures the path cost method used for Rapid Spanning
Tree and Multiple Spanning Tree. Use the
no
form to restore the default.
Syntax
spanning-tree pathcost method
{
long
|
short
}
no spanning-tree pathcost method
•
long
- Specifies 32-bit based values that range from 1-200,000,000.
•
short
- Specifies 16-bit based values that range from 1-65535.
Console(config)#spanning-tree priority 40000
Console(config)#
Содержание TigerSwitch 1000
