5 Adjustments
5-19
5.3.2 Advanced Autotuning Procedure
The following procedure is used for advanced autotuning.
Advanced autotuning is performed from the S.
The operating procedure from the S is described here.
CAUTION
• When using the DRIVER with Jcalc = OFF (load moment of inertia is not calculated), be sure to set a
suitable value for the moment of inertia ratio (Pn103). If the setting greatly differs from the actual
moment of inertia ratio, normal control of the DRIVER may not be possible, and vibration may result.
• When using the MP2000 Series with phase control, select the mode = 1 (standard level). If 2
or 3 is selected, phase control of the MP2000 Series may not be possible.
(1) Operating Procedure
In the S Σ-V component main window, click
Tuning
and then click
Tuning
.
Click
Execute
. The Tuning main window appears.
Содержание LECYU Series
