-10-
No.JXC
※
-OMX0002
4. ACT Controller Installation
4.1 Installation
Install the controller setting software (ACT Controller), which has been downloaded from the SMC website.
Create a folder on the PC and unzip the ACT Controller in the folder.
Once the folder is unzipped, the ¥EN (Ver1200) folder is created, so execute the Setup.exe in the folder.
When the installation is complete, “ACT Controller Menu” is displayed on the desktop. Clicking this icon starts
up the ACT Controller.
Read chapter "4.2. Check of the Communication Port" before starting the software.
4.2 Check of the Communication Port
Before using this setting software, it is necessary to check the communication port number (COM No.) which
has been assigned to the communication unit. Check the COM No. using the Device Manager.
Connect the communication cable LEC-W2A-C to the USB port via the USB cable (A-miniB), and start the PC
Device Manager .
Check the COM No., which is displayed in “USB Serial Port (COM
□
)
” of the “Port (COM & LPT)”.
(In the case of the figure below, the COM No. is "8".)
The COM No. will change depending on the USB port where the communication cable is currently
connected to.
Please check it after connecting the communication unit.