SMC Networks JXCEH, Руководство по эксплуатации

Страница: 60 / 85

-59-
No. JXC
※
-OMY0008
14.8 Noise filter set
ＬＥＣ－ＮＦＡ
Noise filter set
Assembly procedure of Actuator cable:
1) Mount a noise filter around the single wires of the actuator cable close to the controller connectors.
Next, fasten a cable tie to the shrink sleeve as shown (refer to A1).
2) Mount a noise filter to the motor cable, and fasten with a cable tie at both ends.
Assembly procedure of Power cable:
1) Mount a noise filter around the power cable close to the power supply plug. And the cable need to
be with 2 turns.
2) Fasten with the cable ties at both ends to prevent the noise filter from moving.
Caution
When installing a noise filter on the actuator cable and the power cable, bundle all of the single wires
together and then house them inside the noise filter case. When locking the noise filter, make sure not
to damage the wires.
Attach the noise filter at the root of the cable immediately next to the connector.
When unplugging the actuator cable connectors CN2 and CN3 from the driver, remove the cable tie
and move the noise filter towards the shrink sleeve. After re-mounting, return the noise filter to its
original position and re-fasten the cable tie.
A1
(28.8)
(42.2)
Catch closed
(33.
5)
(140)
Cable tie (3pcs.)
Noise filter (2pcs.)
(12.5)
Actuator
cable
A1
Controller
Connectors
(ENC, MOT)
Single wires
Cable tie
Shrink sleeve
Noise filter
Power supply plug
Cable tie
Noise filter
Power cable
(It is need to be prepared by the user)
the cable with 2 turns