![background image](http://html.mh-extra.com/html/smc-networks/izg10/izg10_operation-manual_1299113015.webp)
Doc. no.IZ
*
-OMX0012
15
把持部
―
Removing the nozzle and emitter assembly
―
- Be sure to stop the power supply and compressed air supply to the product.
- Remove the nozzle by turning it by hand in direction shown below.
- Pinch the white shaded part of the emitter assembly using pliers, and remove it by turning
as shown below.
―
Mounting the nozzle and emitter assembly
―
- Mount the replacement emitter assembly by rotating it as shown in the figure below with the
protective cap attached.
- Always remove the protective cap after mounting the emitter assembly.
(Be careful when removing the cap, as there is a danger of injury due to the emitter tip).
- Hand-tighten the nozzle in the direction shown below until it does not turn any more.
(The recommended tightening torque by hand tightening is 0.1 to 0.2 N·m.)
Static neutralizing performance is deteriorated when the nozzle is loose.
Protection cap
Nozzle removal
Emitter assembly removal
Mount the emitter assembly
Mount the nozzle
Gripping part