- 8 -
Setting of dipswitch
△
！
CAUTION
①
Turn off the power supply while setting the switch.
②
If there is foreign matter or water droplets around the switch cover, clean it off
before opening the cover.
③
Refer to the drawing below for the setting at the time of shipment from the
factory. Confirm the condition of switches before use and reset if necessary.
■Setting procedure
①
Loosen the screws of the switch cover.
②
Open the cover from the bottom upwards.
(See drawing)
③
Set switches according to the following procedure.
④
After setting the switch, tighten the switch cover
in the reverse order of the above procedure.
(Tightening torque 0.6 to 0.8Nm)
■Selection of ADDRESS setting mode
Node address of the product can be set by software
mode (SW) and hardware mode (HW).
When software mode is selected, the node address
is set by the communication master. Setting range is 1 to 125.
The device supports "Set_Slave_Address_Supp"
function. But the “no further
changed allowed” function is not included.
Refer to setting procedure below when hardware mode is selected (condition at
the time of shipment : The switch is installed on the left HW)
■
ADDRESS set switch
Hardware mode can set node address by the
switch on the right.
・
Address setting range is 01 to 99.
・
Setting at the time of shipment is 01.
９０°
Ｎ
Ｏ
HW
／
SW
1
6
4
7
9 0
2
3
5
8
1
6
4
7
9 0
2
3
5
8
×１０ ×１
