1.
Check that the ferrule is mounted inside the
fitting as shown in figure on the right.
Hand-tighten the union nut. Ensure ferrule is
aligned properly.
Preparation
2.
Insert the nozzle until it touches the fitting
body. Then, mark a line on the nozzle at the
edge of the union nut.
3.
Remove the nozzle once, and check the
dimension from the end of the nozzle to the
marking. If the dimension is different from
the 17mm, verify the alignment of the nozzle
and adjust.
Tightening
4.
After verifying the dimension, insert the
nozzle into the fitting body again.
Confirm that the nozzle is inserted down to
the marking.
5.
Using the tightening tool, tighten the union
nut so that the gap between the fitting body
and the union nut becomes 2mm or less.
6.
Pull the nozzle by hand to ensure that the
nozzle is secure.
Nozzle
Insert the nozzle until it touches
the bottom of the fitting body.
Bottom of the
fitting body.
Remove it once, and check the dimension.
Body
Union nut
Ferrule
Insert to the marking.
Gap 2mm or less
Union nut
How to mount a nozzle to the Impact-Blowgun (Series IBG)
Tighten the union nut until it touches the body.
Marking
Put a mark.
Marking
Approx. 17mm
Tighten the union nut so that
the clearance is 2mm or less.
-
5
-
5
.How to mou
nt
a nozzle
