(203) 776-2813 • FAX (203) 776-8294
APPLIED ENGINEERING PRODUCTS
www.aepconnectors.com • [email protected]
7
Body assembly
Backnut
Insulator
Solder Ferrule
Contact (male
or
female)
Solder
—
Assemble insulator and contact onto cable dielectric and
center conductor. If insulator is not flush against solder ferrule due to
dielectric extrusion, retrim dielectric.
—
Solder contact to center conductor by heating rear of contact
(do not feed additional solder through inspection hole in contact).
Backnut
Solder Ferrule
Body assembly
Cap
Insulator
Solder
Solder
Straight Connectors—Semi-Rigid Cable
Cable Trim Dimensions
Right Angle Connectors—Semi-Rigid Cable
Parts list
B
A
Jacket
Center conductor
Dielectric
—
Trim cable per trim code below; tin end of center conductor.
—
Slide backnut over cable. Slide solder ferrule over cable until it stops
against cable jacket.
—
Solder cable jacket to ferrule.
1
2
3
—
Insert cable assembly into body assembly. Tighten to 90–100
inch-ounces torque. (Hold cable/hardware assembly stationary
and rotate body when tightening.)
—
Place insulator in body cavity, and press cap into place.
Properly assembled cap will be slightly below end of body assembly.
—
Insert cable assembly into body assembly. Tighten to 90–100
inch-ounces torque. (Hold cable/hardware assembly stationary
and rotate body when tightening.)
—
Solder center conductor into notch in rear of contact with
.025–.032" diameter chisel-tip soldering iron.
—
Solder should cover center conductor, but not extend over top
of notch in contact, or exceed contact diameter.
—
Trim cable per trim code below; tin end of center conductor.
—
Slide backnut over cable. Slide solder ferrule over cable until it
stops against cable jacket.
—
Solder cable jacket to ferrule.
1
2
Parts list
CONNECTOR TYPE A
B
STRAIGHT CONNECTORS–.085" cable
.090 .170
STRAIGHT CONNECTORS–.141" cable
.105 .130
RIGHT ANGLE CONNECTORS
.110 .150
Cable Assembly Instructions
Solder-clamp connectors for semi-rigid cable
3
