7008ABR – Manual
36
14.
In the [Configure Standard TCP/IP Port Monitor] dialog box you will need to configure some
additional settings. Please confirm these settings below:
•
Port Name: IP_192.168.2.1*
•
Printer Name or IP Address: 192.168.2.1*
•
In the [Protocol] section click on the “LPR” option
•
The [Raw Settings] section should be grayed out
•
The LPR Settings section should have the Queue Name set to one of 2 options depending
on the version of Barricade you are using.
•
The [Queue Name] is “LPT1” (without the quotes).
•
Verify the [LPR Byte Counting Enabled] and [SNMP Status Enabled] option is unchecked.
* This should be the same information that was configured in Step 7.
15.
Once you have verified all of these settings, click the [OK] button to save these settings and
close the [Configure Standard TCP/IP Port Monitor] window.
16.
Click [Next] to continue and view a summary of the configuration that you have just
completed.
17.
Click the [Finish] button to complete the configuration process of the TCP/IP port
18.
The [Add Printer Wizard] will now guide you through the Printer Driver installation for the
LPR port you just installed.
19.
In the dialog box listed below, choose the Manufacture of the printer that you have, and then
choose your model of printer. If your printer is not listed here, then please refer to your
