SMC Networks 6724AL2, Руководство по управлению

Страница: 298 / 424

C
OMMAND
L
INE
I
NTERFACE
3-110
Command Mode
Global Configuration
Command Usage
Bridge priority is used in selecting the root device, root port, and
designated port. The device with the highest priority becomes the STA
root device. However, if all devices have the same priority, the device
with the lowest MAC address will then become the root device.
Example
spanning-tree pathcost method
Use this command to configure the path cost method used for Rapid
Spanning Tree. Use the
no
form to restore the default.
Syntax
spanning-tree pathcost method
{
long
|
short
}
no spanning-tree pathcost method
•
long
- Specifies 32-bit based values that range from 1-200,000,000.
•
short
- Specifies 16-bit based values that range from 1-65535.
Default Setting
short method
Command Mode
Global Configuration
Command Usage
The path cost method is used to determine the best path between
devices. Therefore, lower values should be assigned to ports attached to
faster media, and higher values assigned to ports with slower media.
Note that path cost (page 3-111) takes precedence over port priority
(page 3-114).
Console(config)#spanning-tree priority 40000
Console(config)#