2
3.
Das SMB SOLAR-MULTIBOARD
Figure 1: General view of the SMB SOLAR MULTIBOARD
The non-slip surface must be kept clean at all times to maintain its non-slip properties.
The contact surface must also be kept clean at all times to prevent dirt particles from
damaging the glass surface of the PV modules when a service technician steps onto
the board. The entire contact surface must rest flat on the glass surface and the frame
of the PV module.
The handle end must always be positioned facing downwards in the direction of slope,
i.e. towards the lower edge of the solar panel. The board has an integrated handle for
ease of use. The clip end must always face upwards against the direction of slope, i.e.
towards the upper edge of the solar panel, and be pushed into position (figure 1 & 2).
Make sure that the two clips on the clip end are carefully inserted in the existing gap
between the framed PV modules (figure 2)
Figure 2: Detailed view of clips
Non-slip surface
Contact surface
Handle end
Clip end
