1
Instructions for the Use of SMB SOLAR MULTIBOARDS on
Photovoltaic Arrays with Framed Modules
1.
General introduction
Solar panel manufacturers stipulate that you must not walk or place concentrated loads
on photovoltaic modules as incorrectly distributed weight may result in the formation
of micro cracks in the solar cells. The damage ranges from a small loss of performance
to the complete failure of individual modules.
However, there is an increasing amount of work on photovoltaic arrays, such as
servicing, repairs or cleaning, that requires you to walk or place weight on the
modules.
The SMB SOLAR MULTIBOARD is a lightweight, mobile, non-slip working
platform that enables you to work on framed photovoltaic modules without damaging
them.
SMB SOLAR MULTIBOARDS may be installed on the solar panels only for the
duration of the works and must be removed after the job has been completed.
2.
Safety regulations
When using the SMB SOLAR MULTIBOARDS you must comply with the general
safety regulations for working on PV arrays and for working on scaffolding. The use
of SMB SOLAR MULTIBOARDS does not exempt you from observing the following
safety regulations:
BGI 515 Personal protective equipment
BGI 656 Safety when working on roofs
BGI 659 Safety when cleaning buildings
BGI 663 Handling of work and protective scaffolding
Accident prevention regulations for winches, lifting and towing equipment
Accident prevention regulations for first aid
