SmartStore SS3025, Руководство по сборке

Страница: 14 / 16

SECURING SHED
13
YOUR SMART STORE SHED IS NOW COMPLETE. RELAX …...
Secure your shed using Treated Timber Pegs or a Bolt Down Kit
TIMBER PEGS—WOODEN FLOOR

The optional Smart Store Timber Peg Down Kit includes six H5 treated
timber pegs that can be hammered into the ground and then attached to
the Base Plate with stainless steel screws. A Sentry timber floor can then
be fitted on top of the Base Plate.
BOLT DOWN KIT—CONCRETE

The optional Smart Store Bolt Down Kit includes 6 x galvanised
brackets, screws and dynabolts.

Space the brackets evenly around the shed and fix to the Bottom
Plate and the concrete slab. A 10mm masonry drill bit is required.
OPTIONAL SENTRY FLOOR

Position the Floor Joists centrally between the side
Base Plates and skew nail each end with two 75mm
nails.

Check that the shed is sitting level and square and
that the diagonal Bottom Plate measurements are the
same.

Place the floor boards in position and nail securely
(10 x 50mm nails per board).
IMPORTANT— CLEAN UP
REMOVE ALL DRILL FILINGS FROM ROOF, WALLS AND CHANNELS
THOROUGHLY. FAILURE TO DO THIS WILL RESULT IN CORROSION
AND COULD THEREFORE VOID THE WARRANTY
.
FIT PADBOLT

Rivet Padbolt to door and keeper onto Door Jamb as
shown.
FIT BACK PADBOLT

Rivet back pad bolts to pad bolt supports then rivet pad bolt sup-
ports to back of small door (Top and bottom)

Using 10mm drill bit, drill hole into top and bottom timber plates
FRONT BASE PLATE
BACK BASE PLATE
JOIST
JOIST
JOIST
JOIST
Weatherstrip
Edge of
Door
Padbolt
Support
Padbolt
Top Plate