O
PERATION
S
YSTEMS
- 200 S
ERIES
C
ONTROL
24
Programming the filter cycles
When a filter cycle begins, pump 1 will turn on high speed for one minute to purge the plumbing. After the
minute has elapsed, pump 1 will run on low speed for the duration of the cycle, filtering and pumping ozone
into the water.
Setting filter cycle duration
Press and hold Light key until the display shows dxx, with “xx” representing
the duration in hours. (default: 2 hours)
Use Up or Down key to change setting.
0 = no filtration
24 = continuous filtration
Note: it is not recommended to set this to “0”.
The “Filter” indicator light lights up when a filter
cycle is on.
Filter cycle frequency
This function tells the electronic control center how many times a day you
would like it to run the filter duration. It essentially is multiplying the filter
duration by however many units of frequency that you choose. Example-
duration=6, frequency=2, the spa will run two filter cycles, each having a
duration of six hours, for a total of twelve hours per 24 hour period. The
control center will not allow you to enter any combination equaling more
than 24 hours. To set the frequency:
Press Light key again. The display will show Fx, with “x” representing the
number of filter cycles per day (up to 4). (default twice a day)
Use Up or Down key to change setting.
When the desired setting is displayed, press Light key to confirm. A filter
cycle will start up immediately.
The “Filter” indicator light lights up when a filter cycle is on.
