11
OPERATION
(Check off box when complete)
Run the car and verify the following:
No Faults
Make sure the car is moving without triggering a fault either on the
Smartrise SRU or the drive. If the SRU board displays a “Drive Fault” on
the SRU, look at the drive to see what the fault is. The most common
fault is “Encoder Flt”.
o
Go to “
Troubleshooting – Drive Fault / Encoder Flt
” for corrective
actions.
Proper Direction
Make sure the car is moving in the same direction as the control switch
on the Run Bug.
o
Go to “
Troubleshooting – Wrong Direction
” for corrective actions.
At Speed
Make sure that the car is moving at the proper inspection speed
(approx. 50 FPM).
o
Go to “
Troubleshooting – Car Moving Too Slow or Rough
” for
corrective actions.
Under Control
Make sure that the car is moving under full control. The car should stop
when commanded from the Run Bug. Verify that the car runs with no
faults for 10 seconds or more.
o
Go to “
Troubleshooting – Brake Not Lifting
” for corrective actions.
