If the deck has a sloped edge, attach the two
square plastic pieces to the end of metal
bracket to make it level. Use the thicker
square piece for greater gradient slope. It
is important to make the bracket level so
that the alarm unit can be held vertically.
Clamp the unit onto this metal bracket by the
2 sets of “U” shaped plastic clamps. Tighten
the screws, but do not strip the threads.
Place the
u n i t
s u c h
that the
w i d e
side of
t
h
e
m o v i n g
s e n s o r
is parallel to the side of swimming pool wall.
Check the sensor in the water. The sensor is
buoyant and should stay upright. If the
sensor lies on its side, please contact your SMARTPOOL immedi-
ately. The sensor must remain in an upright position while it is in the
water.
If you have to place the unit near the return, heavy water current may
set off the alarm. If this happen, put the sensor cap onto the sensor
cage as shown. Place the sensor cap against the water current.
Please note that sensor cage with a sensor cap
will reduce the sensitivity of the unit. Check the
unit function according to that described in the
Sensitivity Adjust before use.
NOTE: The deflector will reduce sensitivity. Test
the alarm unit as described in
Sensitivity Adjust section before
use
6
1234567890123456789012345678901212345678901
1234567890123456789012345678901212345678901
1234567890123456789012345678901212345678901
1234567890123456789012345678901212345678901
1234567890123456789012345678901212345678901
1234567890123456789012345678901212345678901
1234567890123456789012345678901212345678901
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
Pool Wall
wide side
of the moving
sensor is
parallel to the
pool wall
“U” shaped
Plastic Clamps
