Please always install the Transmitter’s battery
BEFORE
install the
receiver’s batteries because it is a wireless training system. The Transmitter
has to be power on then the receiver is able to receive the code from
transmitter.
The Vibration and Shock function might not work if install the batteries incorrect or did
not pair the receiver with transmitter correctly.
Step 3: Install the Electrodes for the Receiver.
Randomly pick one pair of electrodes and
screw for receiver. (Please pick the same
size electrodes for the receiver.)
Step 4: Adjust the collar to fit your pet.
To ensure a proper fit, please follow the steps below:
1.
Put the strap on the receiver.
2.
With your pet standing, centre the collar receiver where contact points are
underneath your pet’s neck, touching the skin.
3.
The collar receiver should fit snugly, yet loose enough to allow on finger to fit
between the strap and your pet’s neck. If the strap is too long for your pet, cut
off the excess length.
4.
Allow your pet to wear the collar for several minutes and then re-check the fit.
Check the fit again as your pet becomes more comfortable wearing the collar
receiver.
NOTES:
The Transmitter and Receiver will get in the Save Mode if you do not use it for
2 minutes.
Please gently shack the receiver, the receiver will get back to the standby
mode. And the indicated light of receiver will stay on.
We would recommend you to use the tone function first before starting the static
shock and always start from the lowest level of static shock.
4