Intelpage 5W (POCSAG) Transmitter Installation Manual v1.3
5
4.
Installation
Enclosure Mounting
Before mounting the enclosure, you will need to decide where to place the unit. The Intelpage comes
default with rubber feet installed, allowing it to sit on a desk or table, or be stacked upon other plastic
Fusion Series modules.
The kit also includes a wall mounting bracket. To install this bracket:
1.
Use a Philips screwdriver to remove the four screws holding the rubber feet.
2.
Seat the bracket on the base of the unit. It will only fit one way around.
3.
Use the screws that used to hold the rubber feet in position, to hold the wall mount bracket in
position.
Antenna
A suitable antenna capable of handling 5 watts must be connected to the BNC connector on the rear panel.
The antenna for the unit must not be mounted within 5 metres of any other sensitive electronic equipment
including routers, computers or phone systems. See the technical information section below for further
information.
WARNING: The antenna must be placed at least 5 metres away from other electronic equipment to
prevent interference.
