Under
15cm
Installation area
Stability is important to prevent the
product from wandering!
Make sure that the product should not
stand on the power cord.
Before installing the machine, the location
characterized follows shall be selected:
1. Rigid, dry, and level surface
2. Avoid direct sunlight
3. Sufficient ventilation
4. Room temperature is above 0
º
C
5. Keep far away from the heat resources
such as coal or gas.
w
w
W
>
20mm
Unpacking the washing machine
Packaging material (e.g. Films, Styrofoam)
can be dangerous for children.
There is a risk of suffocation ! Keep all
packaging well away from children.
1. Remove the cardboard box and
styrofoam packing.
2. Lift the washing machine and remove
the base packing.
3. Remove the tape securing the power
supply cord and drain hose.
4. Remove the inlet hose from the drum.
Installation of drain hose
1. Completely sleeve the drain hose over
the sewer.
2. Fix and tighten it with a hoop.( As
shown in the figure )
Note: The drain hose of the machine with
upper drain system has already been
assembled before leaving the factory. This
picture is suitable for lower drain system.
Warning!
Do not kink or protract the drain hose.
Position drain hose properly ,otherwise damage might result of water leakage.
If drain hose is too long, do not force it into washing machine as it will cause abnormal
noises.
There are two ways to place the end of drain hose:
1.For lower drain system
water trough
Under 3m
2.For upper drain system
trough
hose
retainer
En
laz
ar
M
in
.8
6
cm
M
ax
.1
00
cm
M
in
.
86
cm
1
0
0
cm
M
ax
.
Levelling the washing machine
The lock nuts on all four feet must be
screwed tightly against the housing.
1.Check if the legs are closely attached
the cabinet. If not, please turn them to
their original positions tighten the nuts.
2.Check alignment of the product with a
spirit level and if required, correct.
3.Loosen the lock nut and turn the feet
until it closely contacts with to the floor.
4.After being locked properly, press four
corners again to make sure that they
has been adjusted properly.
Lock
nut
foot
Raise
Lower
lock
loosen
correct
incorrect
21
22
INSTALLATION
