5.
Ensure the connections to the relay coil are the correct way round ! Failure to ensure this will result in
the relay having exactly the opposite action to that required. The terminal marked “REL –“ on the
PCB should be connected to the unmarked coil contact on the relay. The terminal marked “REL+” on
the PCB should be connected to the coil contact marked with a “+” on the relay.
WARNING
Incorrect connections to any of the terminals may cause permanent damage to the unit which
will not be covered under warranty.
Specifications.
Current consumption:-
Standby
< 0.2mA (< 200uA)
Relay actuation
< 3 Amps
Shutdown
< 12mA
Normal voltage operation range
10 to 16 volts
[021212]