4. Setup Controllers and Cables
a. Using 3M tape or small screws, secure both controllers to a dry location safe
from water drips or flooding. The controllers are NOT waterproof.
b. Using 3M tape or zip ties (not included), secure the power supply to a dry
location safe from water drips or flooding. The power supply is NOT waterproof.
5. Setup Self-Cleaning Assembly
a. Using supplied nylon thumb screws, working on one side at a time, align the
holes and hand-tighten. It should be secure but not overly tight.
b. Repeat for the other side
c. Assembly should look like this
d. Slide the motor spool onto the motor hex gear and hold with one hand. With the
other hand, insert the open end of the spool into the hole on the removable motor
spool and secure the piece with 2 thumb screws. Do not overtighten.
e. Remove filter material roll from packaging. Slide the filter roll over the roll holder
piece and slide the piece onto the bracket.
f. Feed the paper around the paper guiding rods back up to the other side and tape
with a small piece of tape (either the tape included with QR Code or shipping
