(949)429
-
3303
Smartenit.com
Technical Support
© 2018 Compacta International, Ltd.—Rev 10/3/2018
ZBMLCSR and Smartenit are trademarks of Compacta International, Ltd
Zigbee is a registered trademark of the zigbee alliance
Quick Start Guide
Setup
1)
Factory Reset (Restore Factory Settings)
While powering the device, press the SET button and release it once the device powers up. Alternatively, if
the device is already joined to a Zigbee network, quickly tap the SET button 13 times. The Status LED will go
out for 1 second and then begin flashing rapidly. The ZBMLCSR will then search for an open Zigbee net-
work to join.
2)
Joining device to a Zigbee network
1.
Set network controller to discover devices (Open Permit Join)
2.
As the ZBMLCSR joins, the Status LED blinking rate will slow until it stays solid, indicating it has fully
joined the Zigbee network.
3)
Binding to be controlled by other devices
To allow On/Off control by another device, tap the SET button once quickly and within 1/2 second press
and hold it for 3 seconds. The Status LED will blink per the pattern described in the Status LED Indications
table above.
4)
Allowing other devices to join Zigbee network (Open Permit Join)
As a Zigbee
“
Router
”,
the ZBMLCSR can also be put in discovery mode to permit other devices to join the
Zigbee network. Do note that ultimately the network manager device will decide whether to allow the new
device to fully join. Assuming the ZBMLCSR is already in a Zigbee network, it can open the network for oth-
er devices to join as follows:
1.
Press and hold the SET button for 6 seconds. The STATUS LED will blink once per second and the net-
work will be open for joining for up to 4 minutes
2.
Permit
-
join can be stopped by pressing and holding the SET button for 3 seconds. The LED will stop
blinking.
SET Pushbutton Functionality
Operation
Pushbutton
Device Behavior
Leave Network
Tap 13 times
Status LED will begin
fast blinking
Close Permit Join
Press and hold for 3
seconds when de-
vice is in open per-
mit join
Status LED will stop
flashing
Soft Reset (Reboot
Device)
Tap 10 times
Request Firmware
Update (OTA)
Tap 6 times
Restore Factory Set-
tings
Tap 9 times
Status LED Indications
Pattern
Indication
Fast Flashing
Searching for network
Solid
Joined to network
Flash once per second
Open permit join
Short blip, pause
-
0.5 secs
Binding to Endpoint 1
(On/Off)
2 blips per second
Disconnected from net-
work
Load LED Indication
Color
Indication
Off
Load is de
-
energized
