(949)429
-
3303
Smartenit.com
Technical Support
© 2018 Compacta International, Ltd.—Rev 10/3/2018
ZBMLCSR and Smartenit are trademarks of Compacta International, Ltd
Zigbee is a registered trademark of the zigbee alliance
Quick Start Guide
Wireless Metering Switch (Load Controller)
ZBMLCSR Model #4040C
About this Product
This high power switch is ideal to wirelessly moni-
tor and control higher voltage (up to 240VAC)
and/or high current (up to 40A) appliances such
as electric water heaters, pool pumps, booster
pumps, etc. The device interfaces wirelessly with-
in IoT/Home Automation networks where it can
be controlled by automation hubs using the
Zigbee protocol.
For energy monitoring/management, the device
measures the energy consumed as well as other
parameters such as power, voltage, current, pow-
er factor, etc.
Install with the tips and suggestions below to get
the benefits of the Internet of Things through
your automation controller.
Installation
For outdoor installation, it is imperative that all water tight precautions are taken to ensure the life and safe-
ty of your load controller.
The device can be installed indoors or outdoors and may
be mounted to a junction box or panel through the pro-
vided
3/4”
connector, or to a surface through the readily
accessible mounting holes on the back of the unit. An
optional mounting kit consisting of four mounting tabs
and screws is sold separately. Using this kit does not re-
quire opening the device.
When mounting outdoors through flexible conduit, a wa-
ter
-
tight connector (such as 3/4NPT #P472) must be
used.
To maintain its water tight
specification, the device
uses a seal on its lid that
that matches a
“
lip
”
on the
case bottom. If opening
the device to change the connector or to mount it through the internally accessible
holes, disconnect the electrical supply and do not disturb the sealing gasket or
damage the sealing lip when closing it. Avoid overtightening the lid screws to main-
tain case integrity and water tightness.
Optional Mounting Kit
Wire Color
Connect To
Black
Electrical service line 1 (120V: Hot, 240V: L1)
White
Electrical service line 2 (120V: Neutral, 240V: L2)
Red
Electrical load
LOAD LED
—Green if the
load is energized (switch
is ON)
SET Pushbutton
—
Toggles switch on/off,
restores factory settings,
joins device to network,
binds to other devices.
STATUS LED
—Indicates
network and binding status
Typical 220V Installation
