USER’S MANUAL PAGE 9
TECH-5000P
4. Connect the EC5 plug of smart jump clamp to the ENGINE
START socket of TECH-5000P Power BANK. Wait a few seconds,
the green LED light on smart jump clamp should be lit. If not, please
refer to “BOOST” OPERATION section.
5. Try starting the vehicle (turn on the ignition switch). Most vehicles
will immediately start. Stop if the vehicle does not start after
5 seconds of engine cranking. The jumpstart feature is designed
for short term operation only, and more than 5 seconds may cause
damage to the unit. Allow the jump starter to cool down for at least 3
minutes after each jumpstarting.
6. Disconnect the smart jump clamp from the TECH-5000P Power
Bank immediately after engine starts, and then remove from battery
terminals.
“BOOST”OPERATIONS:
1. Under normal circumstance, the green LED light should be
turned on automatically. If not, please do the following: with
correct connection between Jump Starter and vehicle battery
(Red LED keeps on and green LED is off), press and hold
BOOST button for 3 seconds (after a buzzer sound, the green
LED is on and red LED is off). Usually this is because the
vehicle battery capacity is low.
2. Start the engine (same method as the normal operations in
Page 9).