Transmitter
Item No.:301332
Power Switch
Antenna
Steering Trigger
Throttle Trigger
Steering Trimmer
Throttle Trimmer
Steering Reverse
Throttle Reverse
Steering Wheel
Steering Trigger
Battery Case
LCD Light
15%-30% fuel
Receiver
Receiver switch
Servo-2
Servo-1
Receiver crystal
Antenna
The following items are needed for assembly. You must buy them from the local hobby shops apart from the kits
we provided.
please read this instruction manual carefully before operation.
NOTICE
Additional tools needed to buy
Tool needed for assembly
6v Battery case
Receiver
18kg Servo (L)
7.2kg Servo (S)
1.5 mm
2 mm
2.5 mm
3 mm
4 mm
5 mm
Hobby knife
Scissor
Hexagonal wrenches
Cross wrench
（
S
）
Cross wrench
（
L
）
Philips screw driver(small)
Philips screw driver (large)
Needle nose pilers
Side cutter
Instant adhesive
2-Channel Transmitter system
Please read the transmitter system instructions carefully
before use. The servo must be set at the center position
before installation. To set the servo to neutral position,
turn on the transmitter and receiver . Set the servo rod at
the center position, if stop; please turn off the receiver
and the transmitter in succession. The servo will be at the
proper position.
Battery case
Sleeve for plug starter
Additional items needed for starting engine.
Fuel pump
Air filter oil
01