Multisensor 6 in 1
User manual
Rev. 1 del 30.11.2022
Pag. 4/7
Specification
Power supply
Micro USB (included), 2 CR123A batteries (1 year battery life) or 1
CR123A battery (placed in slot 1, shorter operating time)
Protocol
Z-Wave
Frequency range
868.42 Mhz
Motion range
2 ~ 10 m
Viewing angle
360°
Detected temperature range:
0°C ~ 40°C
Humidity detected
8% ~ 80%
Brightness detected
0 ~ 30,000 lux
Operating temperature:
-10°C ~ 40°C
Operating range
30 m in open field
Dimensions
60 x 60 x 40 mm
Package contents
• Multisensor.
• Battery cover.
• Rear arm.
• Double-sided tape.
• Screws (x2).
• Micro USB power cable.
Installation
1)
Remove the battery cover by pressing on the appropriate tab, and insert the CR123A batteries making
sure that the polarity is correct. Then close the lid.
If you want to power the device via the supplied Micro USB cable, you will need to insert it into the
appropriate slot.
Annotation:
The MultiSensor can also be powered by a single CR123A battery. In this case it will have to
be changed more frequently than inserting two batteries (average life of 1 year). If you intend to proceed,
insert a CR123A into the slot marked with the number 1.
WARNING!
he device is not compatible with rechargeable CR123A batteries.
2) Make sure you have positioned the battery cover correctly and locked it.
Inclusion
Before starting the procedure for including the device in a Z-Wave network, check that it is turned on, then
make sure that the MyVirtuoso Home gateway is in inclusion mode (refer to the relevant manual available on
