9
LED ON CONDITION
GREEN Channel is Busy (in use); or not programmed (if the
channel has not been programmed a beep will be heard
every four seconds)
RED PTT is pressed; transmitter is activated
Flashing RED Battery is low when PTT is pressed.
CHANNEL SELECTION
Rotate the CHANNEL SELECTOR switch until the knob’s pointer is at the desired
channel number. Each time the switch is turned to a different channel, a beep will
be heard.
MODE SELECTION
Pressing the FUNC button changes the radio’s mode. To select the Monitor Mode,
press the FUNC button and when a burst of audio noise is heard, the radio is in the
monitor mode
TONE OPERATION
To select the sub-audible Tone Mode, press the FUNC button and if the TX/Busy
indicator blinks once and a single beep is heard, the radio is in the Tone Mode.
NOTE: The Unit can be programmed by the Dealer for sub-audible and or audible
tones. Each channel may be programmed for non-tone, for the same tone or for a
different tone. Each channel can have it’s own unique tones on TX and RX.
If a signal with an improper or non-matching tone is received, the BUSY LED will
light, but the squelch will not open and no audio will be heard.
BUSY CHANNEL LOCKOUT
Busy Channel Lockout (BCL) is a special Tone Mode feature. When enabled by the
dealer, it prohibits monitoring or transmitting on a channel that is receiving a signal with
an improper CTCSS/DCS code. No audio will be heard from the speaker, the GREEN
LED will be illuminated.
