OUTPUT 2
OUTPUT 1
INPUT 1 INPUT 2
EXPAN 1
EXPAN 2
A
B
+3V
SET
RST
N/O
COM
N/C
N/O
COM
N/C
+3V
SET
RST
A
B
FAULT
ACTIVE
RLY 1
RLY 2
3 Prepare the back box
1 Pre installation
2 Components
DO NOT
use the
shaded
area
The unshaded
area is
available for
cable entry
4 Fix back box
All four corner fixing
positions must be used to
ensure a firm fixing
Use suitable fasteners and
fixings.
Fixing position
location within
cavity
118.5 mm
Dual Input / Output Device
Installation Guide
Part number Product description
SC-41-0200-0001-99
Dual Input / Output Device
!
Installation must conform to applicable local installation codes and
should only be installed by a fully trained competent person.
This device contains electronics that may be susceptible to damage
from Electrostatic Discharge (ESD). Take appropriate precautions
when handling electronic boards.
STATUS
DUAL INPUT/OUTPUT DEVICE
LOG ON POINT
The use of a non-metallic spacer should be considered if mounting
the device on to a metal surface.
Unscrew the four lid fixing
screws and remove the lid.
Drill cable entry points where
necessary the in UNSHADED
area.
Cable glands should be used.
The status light pipe should also
now be fitted, as shown below.
6 Configuration
ER14500
AA
ER14500
AA
+
-
+
-
ER14500
AA
+
-
Refer to the programming manual (TSD155) for full programming
details.
The device must now be added (programmed) to the control panel.
Device powering
Method 1
Magnet application
Method 2
Via computer
Method 3
5 Fit batteries
OBSERVE BATTERY
POLARITY!
!
Carefully unclip the battery cover.
When fitting / replacing batteries, observe correct polarity, using only specified
batteries.
Re-fit the battery cover once all batteries are correctly in place.
STATUS
OUTPUT
2
OUTPUT
1
INPUT 1 INPUT 2
EXPAN1
EXPAN2
FAULT
ACTIVE
*
When batteries are not included, only fit specified batteries.
† The gasket can be fitted to the lid for additional protection.
4x lid screws
Lid
1
2
Back box
3
4
Resistor pack
6
Gasket
†
Batteries (
not included in some regions
*
)
7
5
Status light pipe
(
supplied in resistor pack)
2
1
4
5
6
3
7
Two resistor monitored inputs are available. If both inputs enter an
alarm condition, only the first activated input will be shown at the
control panel.
To ensure correct operation, products must be used within the
specified environmental operating conditions.
