Dual Smoke / Heat Detector and
Combined Sounder Beacon
Installation Guide
Part number
Product description
SC-23-0210-0001-99
SC-23-0220-0001-99
Dual Smoke / Heat Detector and Combined
Sounder-Beacon (VAD RED Flash)
Dual Smoke / Heat Detector and Combined
Sounder-Beacon (VAD WHITE Flash)
1
Pre installation
2 Components
Dust cover
1
2 Dual smoke / heat detector and combined sounder beacon
3
1
2
!
Installation must conform to applicable local installation codes and
should only be installed by a fully trained competent person.
This device contains electronics that may be susceptible to damage
from Electrostatic Discharge (ESD). Take appropriate precautions
when handling electronic boards.
The use of a non-metallic spacer should be considered if mounting
the device on to a metal surface.
4
5 Fit batteries
When fitting / replacing batteries, observe correct polarity, using only
specified batteries.
6 Configuration
ER14500
AA
ER14500
AA
+
-
+
-
ER14500
AA
+
-
Refer to the programming manual
for full programming details.
The device must now be added (programmed) to the control panel.
Device powering
Method 1
Magnet application
Method 2
Via computer
Method 3
4 Fix mounting plate
When fixing to the ceiling, all four fixing positions should be used to
ensure a firm fixing.
Use suitable fasteners and
fixings.
60 mm
60 mm
Where existing electrical
mounting boxes are present,
two fixing positions may be
used.
3 Remove mounting plate
Remove the mounting plate by turning the device ANTICLOCKWISE, to
release it from the mounting plate.
OBSERVE BATTERY
POLARITY!
!
3x ER14505M
LITHIUM 3.6V
©2021 EMS Ltd. All rights reserved. Page 1 of 2
TSD091-0001-99 (Issue 4) 25/08/2021 AJM
Mounting plate
3
Batteries
(not included in some regions*)
4
*When batteries are not supplied, only fit specified batteries.
To ensure correct operation, products must be used within the
specified environmental operating conditions.
SmartCell panel = TSD155
SmartCell WZM = MK067
