SMART Wallbox A0009069206, Инструкция по эксплуатации, Страница: 8 / 24

User information.
To operate your wallbox, please note these instructions:
> The device must always be connected to the protective earth conductor of your electricity supply.
The protective earth connection will be made and checked by the installing contractor. After instal-
lation, only qualified specialist electrical contractors may make changes.
> The wallbox should not be installed in areas of high pedestrian traffic. Installation along thorough-
fares and marked escape routes should be especially avoided.
> When there is no charging procedure under way, the charging cable should always be unplugged
and stored (model variants with charging socket) or inserted into the compartment on the side of the
wallbox (model variants with fixed charging cable) to avoid trip hazards.
> Ensure that the rated voltage and rated current of the device comply with the parameters of your lo-
cal electricity grid and that the rated output is not exceeded during the charging procedure.
> At all times comply with local safety regulations for the country in which you operate the wallbox.
> To disconnect the wallbox completely from the power grid, the power supply must be interrupted
using the upstream fuse(s) and the external residual current circuit breaker (RCCB).
> Never operate the wallbox in a confined space. In particular, you must ensure that the vehicle can
be parked at a suitable distance from the wallbox and connected without any strain on the charging
cable.
> A parking spot for the vehicle must be planned for in the area in front of the wallbox. The distance
between vehicle and wallbox should be at least 50 cm and no more than 5 m.
> Make sure that the cover of the wallbox housing is always closed and locked when in use. Keep the
triangular key for unlocking the door in a place that is only accessible to authorized users.
> Under no circumstances remove the protective cover for electronic components located behind the
housing cover of the wallbox.
> You must not under any circumstances make any changes to the housing or the internal wiring of
the wallbox: Any disregard of this instruction represents a safety risk, fundamentally breaches the
guarantee provisions and may void the warranty with immediate effect.
> Only have qualified, specialist personnel install and/or repair the device. No parts to be maintained
by the user are located inside the device.