SMART PMCspan, Руководство пользователя

Страница: 24 / 64

24 PMCspan PMC Carrier Module Installation and Use (6806800A59C)
Hardware Installation
Installing PMC Modules
2.4 Installing PMC Modules
PCI mezzanine card (PMC) modules mount on the PMCspan. Install the PMC modules on
the PMCspan prior to installing the PMCspan onto the VME processor module. The
PMCspan is keyed to accept only +5V PMC modules. Refer to the installation instructions
that come with the PMC for any prerequisites.
The following cautions should be followed for each procedure in this chapter.
This procedure assumes that you have read the user’s manual that was furnished with your
VME module and that you have properly configured your according to the information in the
MVME5100 or MVME5500 Installation and Use manuals. Refer to the list of documentation
in
Appendix A, Related Documentation .
To install a PMC module on your PMCspan, perform the following steps while referring to the
figure on the next page.
1. Position the PMCspan with the P1 and P2 connectors facing you.
2. Remove the PMC slot filler panel from the PMCspan front panel.
Dangerous voltages, capable of causing death, are present in this equipment. Use
extreme caution when handling, testing, and adjusting.
Inserting or removing modules with power applied may result in damage to module
components. Avoid touching areas of integrated circuitry, static discharge can
damage these circuits.
Figure 2-1 PMC (Expansion) Module Placement on PMCspan