Chapter 3
Using the stand
16
7. Carefully push the center point of the legs to move the stand. Do not push on the upper part of the
stand, as this might cause it to tip over.
8. After the stand is moved, flip the caster brakes down to lock them and secure the stand in place.
9. Connect the power cable to the outlet and secure any cables that run along the floor.
Raising and lowering the stand
WARNINGS
l
Ensure the locking bolts are securely tightened before operating the stand.
l
Do not allow children or people who are not able to safely operate the stand to use it.
l
Lock the casters before raising or lowering the stand.
l
Operating the stand can create a hand-crushing or hand-pinching hazard. To prevent injury, keep
hands and people away from crush and pinch locations on the stand.
l
Allow adequate clearance above and below the stand to ensure safe raising and lowering.
l
Use the stand only on a flat surface.
CAUTION
Do not raise and lower the stand for more than two minutes at a time.
Resetting the stand
The stand needs to be reset before you start to use it.
To reset the stand
1. Connect the stand to a power outlet.
2. Press the
, , and
buttons in sequence, and then press down on the control switch for 5
seconds.
TIP
Don’t allow more than one second between button presses.
The stand moves up 1 cm and then back down.
Unlocking the height-adjustment safety lock
The stand’s height-adjustment mechanism locks automatically after 20 seconds of inactivity. Unlock the