OPERATION
Begin Recording
1.
!
Make sure that the power cable is properly connected and turn on the car
power.
2.
!
Blue LED & Red LED will turn on and flashing slowly simultaneously and
then the Blue LED will remain on. Blue LED light means SVC300GPS is
now ready for recording.
Removing the SD memory card
Turn off the power and then check the BLUE LED light. Once the BLUE LED
light is off, take out the SD Memory Card .
Inserting the SD memory card
Turn off the power and then check the BLUE LED light. Once the BLUE LED
light is off, insert the SD Memory Card .
System Error Buzzer
A ‘Beep Beep’ sound will occur and the BLUE & RED LED lights will flash
simultaneously when there is a system error or SD card is not inserted.
Check the SD Memory Card when this occurs.
12
NOTE:
Recording Modes
•
!
Normal recording (Continuous recording) will start automatically, (if set with your PC)
•
!
Event recording will automatically begin when triggered by the G-Sensor and will
begin with one short ‘Beep’ sound.
•
!
Panic/Manual recording can be started by pressing the RECORD button.
