When the SPC4000 is in DEEP CYCLE MODE,
the DC FAN will turn ON automatically. If the
SPC4000 is over 40C, the DC FAN will turn ON
automatically. Once the SPC4000 is below 35C,
the DC FAN will turn OFF automatically.
FINAL NOTE:
You can CHARGE and DEEP CYCLE 4 DJI Smart
Batteries plus CHARGE your WIFI EXTENDER and
iPHONE simultaneously.
OTHER INFORMATION ABOUT THE SPC4000
AUTOMATIC THERMAL FAN CONTROL
When the SPC4000 power supply output is less
than 8.4v or greater than 13.7v, the charger’s
LED’s will all flash at the same time thus turning
OFF CHARGE MODE AUTOMATICALLY. This is
to protect the battery and the charger. Please
REMOVE the power cord and check battery to see
if there is a circuit short or damage.
Hold Down
Remove Battery
CHARGING YOUR iPHONE or iPAD
1. Turn ON the SPC4000.
5. Turn OFF the
SCP4000.
2. Connect your
iPHONE or iPAD to the
USB port using the ca-
ble supplied by APPLE.
3. When your iPHONE or iPAD shows 100%, it is fully charged.
4. Remove the cable
from the SPC4000.
3. When both LED’s
on the WIFI Extender
are GREEN, it is fully
charged.
4. Remove the cable from the SPC4000.
5. Turn OFF the SCP4000.
LEDs
5. When the battery’s
GREEN LED’s are OFF,
the battery has been
DEEP CYCLED and
charged to full capacity.
2. Hold down the RED
DEEP CYCLE BUTTON
until the LED turns RED.
3. The SPC4000 will
activate the battery and
discharge it to below 5%.
4. Once discharged to below 5%, the SPC4000 will
automatically send the battery into CHARGE MODE.
6. Remove the bat-
tery and turn OFF the
SPC4000
1. Turn ON the SPC4000.
CHARGING YOUR WIFI EXTENDER
2. Connect your WIFI
Extender to the USB port
using the cable supplied
by DJI.
