Page
14
of
17
6.
Installation – Special Cases
There are some special cases where the connection becomes a little bit
complex. Some examples are:
6.1 Invertor Connection
If you wish to connect the loads connected with TS.2S (NL) to work with
invertor, then it is mandatory to insert the Invertor phase wire to Ph terminal (P1)
of the power supply. By default, the loads connected to L2 will be connected
with the Invertor. If we wish to connect other loads of TS.2S (NL) with invertor,
we need to connect the inverter phase with the Ph terminal as follows.
Loads
Ph Terminal
L2
P1
L1
P2
6.2 Two- Way Connection
In TS.2S (NL), a total of only one load is possible to make it work as two-
way. The load connected with L1 can only be made two-way.
Two-way connection depends whether we have connected traditional
switches or Smart Node Touch Switches on the other side.
The following wiring diagram shows a basic two-way connection.
If Smart Node Touch Switches are connected on both sides, then the two-
way connection is possible and the wiring diagram will be as follows
Содержание Touch Switches TS.2S NL
Страница 1: ...Page 1 of 17 Smart Node Touch Switches Model TS 2S NL Product Guidance ...
Страница 13: ...Page 13 of 17 ...
