ECC160 – User Manual
7
Smart-Cover , 1km Lagada-Thessaloniki , P.C.57200,Tel. +302394020077 Email: [email protected] , Website: www.smart-cover.gr
4.Working with the machine
4.1General use
Please follow thesesimple steps for the general use of the Engine Carbon Cleaner:
1. Open the air filter box, remove filter element and clean the area inside in order to avoid dust particles from
entering the engine;
2. Insert the hose of the machine in the air intake manifold inside the air filter box;
3. Turn engine ON and let it work for some time until it reaches normal working temperature (80-90º);
4. At this point connect the power cable on the back of the machine to the terminals of the battery of the car;
5. Press the red power control button and check the amperage in the ammeter;
6. Let the engine work idling for the first 20 minutes with only one button working;
7. Every 10 minutes press hard acceleration pedal in order to improve removal of the carbon deposits;
8. After the first 20 minutes of treatment increase the rotations of your engine to 1000 rpm. Check again
amperage in the ammeter;
9. Keep the machine working for one (1) hour to complete engine cleaning;
10. Every 10 minutes make strong acceleration in order to remove faster carbon deposits.
11. Repeat this operation every 10 000 km.
4.3Cleaning the air filter box
The system is operated by vacuum suction from your engine's air intake which takes the HHO directly to the
combustion chamber mixing it with the air/fuel. The injection point must be done rightafter the air filter box
and the MAF/MAP sensor enhancer. Please follow the next steps:
1.
Open the air filter box and remove the air filter;
2.
In the air filter box please cover the engine air intake
with a cloth to prevent dust particles from entering the
engine;
3.
With an air compressor clean the air filter area so that
it stays completely free from dust particles;
4.
Remove the cloth and insert the hose in the air intake
manifold.
