Fall Monitor
Reset
Low
Battery
Status
Plug the cord end of the sensor pad
into the top of the fall monitor.
Pinch the cord together and route it
through the cord protection recess
on the fall monitor (near the plug input).
Test the System
Test the system.
(figure A). Place pressure on the
sensor pad to activate the pad and the fall
monitor. The fall monitor will beep two
times to indicate that the sensor pad and
the fall monitor are in use.
(figure B). When pressure is removed, the
fall monitor will alert. Press the “Reset”
button on the front of the fall monitor to
silence the alert and reset the system.
Bed Sensor Pad
Position the sensor pad under the resident.
Place the sensor pad under the resident’s
back to be alerted when the resident sits up.
To be alerted when the resident leaves the bed,
place the sensor pad under the resident’s hips.
Chair Sensor Pad
Mount the fall monitor on the chair. Suitable
locations are back of the wheel chair or on
the handle of the wheel chair. Position the
sensor pad on the chair under the resident.
Or
Sensor Pad
Positioned on
the Seat
Fall Monitor
Reset
Low
Battery
Status
2 Beeps
Alert
TL-2100B Basic Fall Monitor Quiet Features
Optional Protective Boot
Call Distributor For Pricing
#1
Plug existing Nurse Call
System into Nurse Call
Port using optional Nurse
Call Cord (NCLA-01). Turn
Volume setting in battery
compartment to silent.
#2
Pager - Plug a 433-NCA
adapter into the Nurse Call
Port. Turn the volume inside
the battery compartment to
silent. This will send a wireless
signal to the 433 Central
Monitoring Unit and Pager to
notify caregiver.
Silent Options To
Reduce Noise
Mounting Brackets
Included
If using mounting brackets, line up the 2
small holes on the bracket with the 2 small
holes on the back of the monitor and insert
the 2 screws provided.
Bed
Chair
PB-05
Back View of the
Monitor Battery
Compartment
Install a 9V
Battery or use
optional AC
adapter (AC-02)
9V Battery
1
9V Battery
Silent Low High
CAUTION: The “silent” setting should only be selected
when the fall monitor is to be used with a facility’s
existing Nurse Call Light system. NO AUDIBLE ALERT
WILL SOUND FROM THE FALL MONITOR WHEN THE
“silent” OPTION IS SELECTED. When this setting is used
improperly, it presents a potentially dangerous condition.
Therefore, you must consult with your distributor for
proper operation.
Establish the fall monitor settings with the switch
inside the battery compartment.
Alert Volume: Select Silent, Low or High alert
volume.
Settings
2
Connect the pad
3
4
5
TL-2100B
SMART CAREGIVER CORPORATION Tel: (800) 650-3637 | www.smartcaregivercorp.com
Need Set-up Help? (800) 650-3637
Quick Start Instructions
