SMART Board Board 600i6, Конфигурация и руководство пользователя

Страница: 53 / 117

C H A P T E R 5
Maintaining your interactive whiteboard system
40
6. Press the
Power button once on the remote control or ECP to confirm that the projector is
operating and that the lamp module is correctly installed.
7. Put the old lamp module in a secure container and handle it gently until you recycle it.
To finish the projector lamp module installation
1. Turn on the projector.
2. Adjust the projector image if necessary (see Adjusting the image on page 21).
3. Access the service menu to reset the lamp hours (see Resetting the lamp hours below).
4. Activate the projector’s alert emails and lamp warnings if they’ve been deactivated (see
Email alerts on page 61 and Control panel on page 56).
Resetting the lamp hours
Once you have replaced the lamp module, you need to access the projector service menu and
reset the lamp hours. To prevent accidental errors, only a system administrator should perform
this procedure.
N O T E
Always reset the lamp hours after you replace the lamp, because lamp service reminders are
based on the current hours of use.
To reset the lamp hours
1. Using the remote control, press the following buttons quickly to access the service menu:
Down , Up , Up , Left , Up .
C A U T I O N
Do not adjust any settings in the service menu other than those listed in this guide.
Changing other settings can damage or affect the operation of your projector and may
invalidate your warranty.
2. Scroll down to Lamp Hour Reset and then press OK .
Both Lamp Hour values (Standard and Economy) reset to zero.
C A U T I O N
Do not reset the lamp hours unless you have just replaced the lamp module. Resetting the
lamp hours on an old lamp can damage your projector as a result of lamp failure.
N O T E
You’re unable to reset the Display Hour value because it’s the running total of hours the
projector has been in use.